Pithy words of wisdom from your favorite Superhero.

AL says, “Machine like a Superhero … if buy a Datron machine you do.”

No wait, that was Yoda.

But AL does say ...

“A ¼” single flute cutter in 6061 aluminum, going 1/8” deep can be run at 45,000 RPM and is cooled by ethanol with a feed rate of 250”/min.  But only with a Datron.”

 “With a Datron machine, a 1/8” double flute high-speed cutter (HSC+) with low helical angle can machine through a 1/8” 6061 aluminum sheet at 50,000 RPM a with a feed rate of 200”/min.”

 “Buy a Datron.  Chicks dig it.”